| 機身 | Metal material |
|---|
| 淨重 | 2.81 kg (6.19 lb) |
|---|
| 毛重 | 3.73 kg (8.22 lb) |
|---|
| 尺寸 | 440.0 mm × 44.0 mm × 220.8 mm (17.32'' × 1.73'' × 8.69'') |
|---|
| 工作溫度 | 0 °C to 45 °C (0 °F to 113 °F) |
|---|
| 儲存溫度 | -40 °C to 85 °C (-40 °F to 185 °F) |
|---|
| 工作濕度 | 5% to 95% (no condensation) |
|---|
| 相對濕度 | 5% to 95% (no condensation) |
|---|
| 供電 | 100 to 240 V AC, 50/60 Hz, Max. 2 A |
|---|
| 最大功耗 | 40 W |
|---|
| 閒置功耗 | 7W |
|---|
| 防雷 | 6 kV |
|---|
| 安裝方式 | Rack (equipped with mounting ears) |
|---|
| Ports | 8 × Gigabit RJ45 port,16 × Gigabit fiber optical port,2 × 10G fiber optical port |
|---|
| MAC 位址表 | 16 K |
|---|
| 交換容量 | 88 Gbps |
|---|
| 包轉發率 | 65.47 Mpps |
|---|
| 內部緩存 | 8.4 Mbits Ports 1 to 26: port isolation mode to improve network security |
|---|
| Port Isolation | Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group. Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection. Support static link aggregation. Support 8 aggregation group(s). QoS is used to allocate bandwidth to different services so |
|---|
| Loop Prevention | Support 802.1D STP. Support 802.1w RSTP. Support G.8032 ERPS. VLAN is used for network scale planning and network health improvement. Support 802.1Q. |
|---|
| VLAN | Configurable VLAN ID from 1-4094. Support Trunk, Access port mode. Support Max. 1024 VLAN. supported: 1. Display the port rate. 2. Display the port bandwidth utilization rate. HPP 3. Display topology information. 4. Display the alarm status. 5. Restart ports and devices. 6. Remotely upgrade the device. Support device management via web. Support DHCP Client. Enabled by default for dynamic assignmen |
|---|
| System Maintenance | Support remote management via Hik-Partner Pro. Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected. Supports 802.1ab LLDP for peer device discovery. Support SNMP v1/v2c for third-party management platform access. Support port mirroring for fault locating. Port rate-limiting is used for port bandwidth adjustment to prevent network Port |
|---|
| DHCP Snooping | disrupting the network and affecting normal network communication, and only allow DHCP packets from trusted ports to pass through. Disabled by default. Port security strategy. |
|---|
| ACL | Support up to 32 ACL entries. Support up to 64 configuration rules under all ACL entries. IPSG can control the security of port access device. |
|---|
| IPSG | Support port, MAC, IP binding. Support 64 security entries. |
|---|
| DDM (Digital Diagnostic | Support real-time monitoring of key parameters in optical modules, such as operating |
|---|
| Monitoring) | temperature, operating voltage, operating current, and Rx and Tx optical power. CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020) CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition)), CE-LVD (EN 62368- 1: 2014+A11: 2017) |
|---|
| Chemistry | CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006) |
|---|