BOSCH PRA-MPS3 安裝、保養、維修

PRA-MPS3

裝喇叭 | 裝PA | 裝Hi-Fi — 硬件連工程一站式

產品簡介

Bosch PRA-MPS3 為PRAESENSA系列多功能電源供應器,專為商場、寫字樓、大型機構嘅IP網絡廣播系統設計,一機可同時供電最多三部功放並整合網絡交換及控制輸入輸出,停電時自動切換後備電池,廣播不中斷。HKEZIT提供原廠行貨連保養、上門安裝、調試及使用教學一站式服務,歡迎聯絡我們查詢 PRA-MPS3 香港價格連安裝報價。

  • 三路功放共用電源+內建電池充電:一部機可同時供電最多三部PRAESENSA功放,並自帶後備電池充電管理,慳機櫃空間之餘停電都唔中斷廣播
  • 內建6port網絡交換機:自帶OMNEO音訊/控制網絡交換功能,支援RSTP環網及PoE,唔使另加獨立交換機,佈線更簡潔
  • 斷電自動切換後備電池:市電中斷會即時切去單顆12V後備電池供電,輸出唔會中斷,適合商場、寫字樓等要求廣播不斷電嘅場所
  • 8組通用控制輸入/輸出:可接火警、保安等外部訊號聯動廣播,亦可輸出訊號畀其他系統,擴充彈性高
  • 19吋2U機架式設計:標準機櫃安裝,適合機房、控制室等專業廣播系統整合
HKEZIT 提供原廠行貨保養。硬件連專業安裝、設定及使用教學一站式報價,無需自行研究安裝與設定。我們同時承接裝喇叭、裝PA、裝Hi-Fi工程,硬件與工程同一團隊負責。
查詢價格連安裝
PRA-MPS3 PRA-MPS3 多功能電源供應器 產品圖片

詳細規格

Mains to DC converterDiode
DC to DC converterFuse Battery charger
Front viewBattery temperature sensor 48 Vdc output A‑B (1‑3, to amplifier 1‑3) 1 48 V 48 Vdc amplifier power supply A‑B (1‑3) Audio lifeline / Power‑save (1‑3, to amplifier
Power onGreen 1‑3)
FaultYellow 24 Vdc auxiliary power supply A‑B
Control input 1‑81
Device fault presentYellow Control output 1‑8 1
Network link to system controller presentGreen
Network link lostYellow 24 Vdc output A‑B
Battery status(to system controller)
Full (float charging)Green
Charging (bulk or absorption charging)Green Network port 1‑5 1
blinking(port 1 and 2 with PoE)
Mains presentGreen
Mains faultYellow Network port 6 (SFP, e.g. for PRA-SFPLX or 6
Rear viewPRA-SFPSX) Chassis ground Architects & Engineers specification - PRA-MPS3
Rear panel indicatorsThe IP‑networked multifunction power supply shall be designed exclusively for use with Bosch PRAESENSA 100 Mbps network Yellow systems. The multifunction power supply shall contain 1 Gbps network Green four independent mains power supplies with power
Device in identification modeGreen to power up to three 600 W amplifiers and to power a
Rear panel controlspower source for all connected loads in case of mains failures. Failover to the backup battery shall be
Device reset (to factory default)Button without interruption of output power. It shall use a single 12 V VRLA backup battery to eliminate the need
Rear panel connectionsfor battery balancing, while maximizing battery lifetime and power density. The multifunction power supply
Mains input with fuseshall have eight general purpose control inputs with connection supervision and eight voltage free control outputs. The multifunction power supply shall provide an interface for control data and to receive a backup Battery 12 Vdc audio channel over OMNEO using an integrated 6‑port CF8/100A Ethernet switch for redundant network connections, supporting RSTP and loop‑through cabling. Two ports shall
Input voltage range115 to 240 Vrms
Input voltage tolerance102 to 264 Vrms
EuropeEN 54‑16 Frequency range 50 to 60 Hz
Inrush current< 20 A
InternationalISO 7240‑16 Power factor (PF) 0.9 to 1.0
Leakage current to safety ground< 0.75 mA (120 V),
Environmental directive compliancy< 1.5 mA (240 V)
SafetyEN/IEC/CSA/UL 62368‑1 Battery power supply input
Nominal DC input voltage12.6 V
ImmunityEN 55103‑2 (E1, E2, E3)
DC input voltage tolerance9 to 15 V EN 50130‑4
Maximum current90 A
EmissionsEN 55032 Under-voltage protection <9V EN 61000‑6‑3 Battery charger ICES‑003
Nominal charging current8.5 A ANSI C63.4
Nominal float voltage13.5 V FCC‑47 part 15B class A
Float voltage control-21.9 mV/°C
MaritimeIEC 60945 (excluding salt mist test) Temperature sensor NTC 10 kohm / β = 3984 K
DNV Type approvalCharging temperature range -15 to 50 °C
RailwayEN 50121‑4 48 Vdc outputs (1‑3)
Nominal DC output voltage48 V
Conformity declarationsMaximum continuous current 4.7 A
Maximum peak current6.9 A
USA/CanadaFCC/c-UL/CSA Nominal DC output voltage 24 V
Maximum continuous current0.7 A
ChinaCCC Maximum peak current 1.0 A
KoreaKE Power save DC outputs (1‑3)
AustraliaRCM Nominal DC output voltage 18 V
TaiwanBSMI Maximum peak current 1.0 A
Russian FederationEAC Power over Ethernet (PoE 1‑2)
EnvironmentRoHS Standard IEE802.3af (mode B)
Maximum PD load12.95 W
QuantityComponent
Power transferControl interface
功耗Galvanic isolation Yes
Load condition3 x PRA‑AD60x Maximum contact voltage 110 Vdc, 125 Vac 1 x PRA-SCL Maximum contact current 1A 1 x PRA‑CSLx Maximum voltage to ground 500 V 2 x PRA-CSE
Mains poweredSupervision
Active mode, idle230 W Battery Disconnect
Active mode, rated power840 W Short circuit
Battery poweredCharging state
Snooze mode46 W Impedance
Power suppliesInput voltages
Heat lossConverter voltages
Idle condition432 kJ/h (410 Btu/h)
TemperaturePer section
Rated power condition480 kJ/h (454 Btu/h)
Lifeline / power save interfaceNetwork interface Link presence
Audio level (100 V / 70 V mode)0 dBV / -3 dBV
Bandwidth (-3 dB)200 Hz to 15 kHz Network interface
Signal to Noise Ratio (SNR)90 dBA
Ethernet100BASE‑TX, 1000BASE‑T
ProtocolTCP/IP
Control input contacts (1-8)Redundancy RSTP
PrincipleContact closure
Galvanic isolationNo Audio/control protocol OMNEO
SupervisionResistance Network audio latency 1 ms
measurementAudio data encryption AES128
Contact closed8 to 12 kohm Control data security TLS
Contact open18 to 22 kohm
Cable fault detection0 to 2.5 kohm / Ports
>30 kohmRJ45 5 (2 with PoE)
Minimum hold time100 ms SFP 1
Maximum voltage to ground24 V
EnvironmentalMechanical
Climatic conditionsEnclosure
Operating-5 to +50°C With mounting brackets 483 x 88 x 400 mm (23 to 122°F) (19 x 3.5 x 15.7 in)
Storage and transport-30 to +70°C Rack unit 19 in, 2U (-22 to 158°F)
防護等級IP30
Humidity (non condensing)5% to 95% Case
Air pressure (operating)560 to 1070 hPa Material Steel
顏色RAL9017
Altitude (operating)-500 to +5000 m (-1640 to 16404 ft) Frame
材質Zamak
Vibration (operating)Color RAL9022HR
Amplitude< 0.7 mm
Acceleration<2G Weight 11.8 kg (26 lb)
Bump (transport)< 10 G Ordering information
AirflowPRA-MPS3 Multifunction power supply, large Power supply with battery charger for up to three
Fan airflowFront to sides/rear amplifiers and a controller, with integrated network
Fan noiseswitch and control inputs and outputs.
Idle condition, 1 m distance< 30 dBSPLA Order number PRA-MPS3
Rated power, 1 m distance< 50 dBSPLA Reliability
MTBF> 1,000,000 h
Europe, Middle East, Africa:Germany: North America: Asia-Pacific:
Bosch Security Systems B.V.Bosch Sicherheitssysteme GmbH Bosch Security Systems, Inc. Robert Bosch (SEA) Pte Ltd, Security Systems
P.O. Box 80002Robert-Bosch-Ring 5 130 Perinton Parkway 11 Bishan Street 21
Phone: + 31 40 2577 284Germany Phone: +1 800 289 0096 Phone: +65 6571 2808
emea.securitysystems@bosch.comwww.boschsecurity.com Fax: +1 585 223 9180 Fax: +65 6571 2699
emea.boschsecurity.comonlinehelp@us.bosch.com apr.securitysystems@bosch.com
www.boschsecurity.uswww.boschsecurity.asia

* 規格以原廠最新 Datasheet 為準。

下載完整PDF規格書

廣播 PA安裝工程服務

HKEZIT 專營裝喇叭、裝PA、裝Hi-Fi工程,PRA-MPS3 由我們供貨、安裝、調試到使用教學一站式完成。無論裝喇叭、裝PA或裝Hi-Fi,均由自家工程團隊上門施工,品質有保證。

裝喇叭裝PA裝Hi-Fi

常見問題

PRA-MPS3 香港哪裡有代理?

HKEZIT 提供原廠行貨連保養,PRA-MPS3 原廠行貨連保養,提供上門安裝、分區設定及排程設定一站式服務,全港 32 區均有服務。

IP 網絡廣播與傳統廣播有何分別?

傳統廣播須由功放拉專用喇叭線至每個廣播點;IP 廣播經網絡傳輸,具備網絡佈線即可安裝,分區及內容以軟件控制,擴展靈活。

可以與 CCTV 聯動嗎?

可以。配合攝影機事件(如入侵偵測)自動播放警告語音,管理員亦可透過平台實時喊話。

PRA-MPS3 定 PLE-1MA060-EU 邊個好?

兩者屬同系列產品,實際應該邊個型號更適合,需視乎現場環境同需求而定。歡迎直接聯絡我們免費現場評估,由工程師建議最合適方案。

PRA-MPS3 保養、維修邊度做?

HKEZIT 提供 PRA-MPS3 原廠行貨連保養,安裝後如有故障可直接聯絡我們安排上門維修,毋須自行聯絡原廠。詳情請參閱廣播 PA安裝工程頁面或聯絡我們查詢保養範圍。

香港安裝服務地區

HKEZIT 於全港各區提供 PRA-MPS3 PRA-MPS3 多功能電源供應器供貨連專業安裝服務(裝喇叭、裝PA、裝Hi-Fi),熱門地區包括:藍田廣播系統安裝觀塘廣播系統安裝銅鑼灣廣播系統安裝鑽石山廣播系統安裝長沙灣廣播系統安裝青衣廣播系統安裝香港仔廣播系統安裝黃大仙廣播系統安裝。港島、九龍、新界全港 32 區均有上門安裝,歡迎聯絡我們查詢 PRA-MPS3 香港價格連安裝報價。

廣播 PA適用場景

PRA-MPS3 PRA-MPS3 多功能電源供應器適合多種場景使用,以下為部分常見安裝場景,歡迎查詢是否適合您的現場環境。

查看更多廣播 PA適用場景,請參閱 廣播 PA安裝工程

相關產品

如需整套廣播 PA方案,請參閱 廣播 PA安裝工程

查詢 PRA-MPS3 連安裝價格

免費上門評估,即日報價,原廠行貨保養

立即查詢