| – UNIMODE-5UD - five IDCs. | box transmitter). – UNIMODE-10UD - ten IDCs. PROGRAMMING AND SOFTWARE: |
|---|
| cial application power | • Can be programmed at the panel with no special software or additional equipment. – UNIMODE-5UD - four NACs. • Programmable Make/Break Ratio. – UNIMODE-10UD - four NACs. • Upload/Download (local or remote) of program and data via integral DACT. – Silence Inhibit. |
|---|
| – Auto-Silence. | USER INTERFACE: – Strobe Synchronization for System Sensor, Wheelock, • Built-in DACT (Digital Alarm Communicator/Transmitter). |
|---|
| Gentex, Faraday, or Amseco devices. | • Integral 80-character LCD display with backlighting and |
|---|
| – Selective Silence (horn-strobe mute). | keypad. |
|---|
| – Temporal or Steady Signal. | • Real-time clock/calendar with automatic daylight savings adjustments. – Silenceable or Nonsilenceable. • ANN-BUS for connection to remote annunciators. NACs and IDCs (2 required for UNIMODE-10UD). • Audible or silent walk test capabilities. tact Ratings 2.0 A@ 30 VDC or 0.5 A @ 30 VAC (resistive). DA-60186:F2 • 12/21/12 — Page 1 of 4 |
|---|
| Controls and Indicators | Wire size: minimum 14 AWG (2.00 mm²) with 600 V insulation. Supervised, nonpower-limited. |
|---|
| LED INDICATORS | Battery (sealed lead acid only) – J12: • FIRE ALARM (red) • Maximum Charging Circuit - Normal Flat Charge: 27.6 VDC |
|---|
| • SUPERVISORY (yellow) | @ 1.4 A. Supervised, nonpower-limited. |
|---|
| • TROUBLE (yellow) | • Maximum Charger Capacity: 18 AH battery for UNIMODE- |
|---|
| • AC POWER (green) | 5UD, and 26 AH battery for UNIMODE-10UD. [Two 18 Ah |
|---|
| • ALARM SILENCED (yellow) | batteries can be housed in the FACP cabinet. Larger batter- ies require separate battery box such as the BB-26 or BB- |
|---|
| CONTROL BUTTONS | 55.] |
|---|
| • ACKNOWLEDGE | • Minimum Battery Size: 7 AH. |
|---|
| • ALARM SILENCE | Initiating Device Circuits – TB4 (and TB 6 on UNIMODE- |
|---|
| • SYSTEM RESET (lamp test) | 10UD only): |
|---|
| • DRILL | • Alarm Zones 1 - 5 on TB 4 (UNIMODE-5UD and UNI- MODE-10UD). |
|---|
| Terminal Blocks | • Alarm Zones 6 - 10 on TB6 (UNIMODE-10UD only). |
|---|
| AC Power – TB1: | • Supervised and power-limited circuitry. • Operation: All zones Style B (Class B). |
|---|
| HZ, 1.00 A. | • Normal Operating Voltage: Nominal 20 VDC. |
|---|
| HZ, 3.80 A. | • Short Circuit Current: 40 mA max. 52416cab.wmf Cabinet Measurements |
|---|
| • Maximum Loop Resistance: 100 ohms. | to open with a system trouble condition if no alarm conditions listed). COMPATIBLE ANNUNCIATORS ADT-ANN-80: Remote LCD Annunciator. Mimics the informa- ADT-ANN-LED: LED Annunciator with three LEDs for each |
|---|
| MODE-10UD only): | 51050(B) dress panel. Red. (For white, order ADT-ANN-LED- |
|---|
| • Four NACs | W.) |
|---|
| • Operation: Style Y (Class B) | ADT-ANN-RLED: LED Annunciator with three alarm (red) indi- |
|---|
| • Special Application power | cators for up to 30 input zones or addressable points. (Red. For white, order ADT-ANN-LED-W.) vides ten Form C relays. 2.5 A maximum per NAC; 7.0 A for UNIMODE-10UD, 3.0 A ACCESSORIES |
|---|
| maximum per NAC. | DP-51050: Optional dress panel. Restricts access to the sys- |
|---|
| • Max. Wiring Voltage Drop: 2 VDC | panel. |
|---|
| ble listed devices. | CHG-75. |
|---|
| Form C Relays – TB8: | BB-55: Battery backbox, holds up to two 25 AH batteries. Relay) power. ering four-wire smoke detectors. DA-60186:F2 • 12/21/12 — Page 3 of 4 |
|---|
| System Capacity | Temperature and Humidity Ranges 49°C/32 – 120°F and at a relative humidity 93% ± 2% RH |
|---|
| Electrical Specifications | (noncondensing) at 32°C ± 2°C (90°F ± 3°F). However, the useful life of the system's standby batteries and the electronic 1.0 A ture ranges and humidity. Therefore, it is recommended that 60 HZ, 3.90 A with a normal room temperature of 15 – 27°C/60 – 80°F. |
|---|
| tion, supervised, nonpower-limited | Agency Listings and Approvals The listings and approvals below apply to the basic UNIMODE- |
|---|
| Cabinet Specifications | 5UD and UNIMODE-10UD control panels. In some cases, cer- • FM Approved |
|---|
| Shipping Specifications | • CSFM: 7165-1574:0204 |
|---|
| 尺寸 | • MEA: MEA: 333-07-E – 20.00" (50.80 cm.) high |
|---|
| – 22.5" (57.15 cm.) wide | NFPA Standards |
|---|
| – 8.5" (21.59 cm.) deep. | The and complies with the following NFPA 72 Fire Alarm Sys- |
|---|
| Weight: 27 lb (12.20 kg) | tems requirements: – LOCAL (Automatic, Manual, Waterflow and Sprinkler Supervisory). – AUXILIARY (Automatic, Manual and Waterflow) (requires 4XTMF). – REMOTE STATION (Automatic, Manual and Waterflow) (Where a DACT is not accepted, the alarm, trouble and supervisory relays may be connected to UL 864 listed transmitters. For reverse polarity signaling of alarm and trouble, 4XTMF is required.) – PROP |
|---|
