honeywell DF-52408 為BEAM355 and BEAM355S，HKEZIT 提供原廠行貨連保養、上門安裝、調試及使用教學一站式服務。詳細規格以下方原廠 Datasheet 欄位為準，歡迎聯絡我們查詢 DF-52408 香港價格連安裝報價。
| environment. | SPECIFICATIONS |
|---|---|
| SLC power. | NOTE: Sensitivity settings are a feature of specific control panels. • Level 1 — 25%. |
| FEATURES | • Level 2 — 30%. |
| • | Listed to UL 268, ULC CAN/ULC S529. • Level 3 — 40%. |
| excess of 230' (70 m). | Alignment Aid: |
| Test/reset features: | MECHANICAL SPECIFICATIONS external power supply). Detector Dimensions: 10.0" H x 7.5" W x 3.3" D (254 mm H x Reflector Dimensions for 16' to 230' (5 to 70m) |
| • Local alarm reset switch. | Applications: 7.9" x 9.1" (200 x 230 mm). Reflector Dimensions for Applications Beyond 230'/70m: RTS151KEY test stations). 15.7" x 18.1" (400 x 460 mm). SENSITIVITY SELECTION |
| See NFPA 72. | selections is only acceptable over a specific distance separation between the detector and the reflector per UL 268. |
| ENVIRONMENTAL SPECIFICATIONS | The chart below determines which selections are acceptable for your installed distance. The sensitivity of the detector can |
| Humidity: 10 – 93% RH noncondensing. | not in the fine adjustment step of the alignment mode, indicated by the illumination of the dual digital display. To set the sensitivity, depress the sensitivity button one time. See |
| ELECTRICAL SPECIFICATIONS | Switch Locations diagram. Once the switch is pressed, the |
| • Voltage: 15 to 32 VDC. | digital display will illuminate and read the current sensitivity (LED flashing, SLC @ 24 V). continue to depress the sensitivity switch until the desired setting is achieved. The digital display will turn off automatically if no further switch presses occur. |
| • Alignment Current: 20 mA maximum. | Acceptable Acceptable DISTANCE DISTANCE |
| • External Supply (BEAM355S only): | between between |
| Voltage — 15 to 32 VDC | Sensitivity Percent Display Detector Detector |
| Current — 0.5 A maximum. | Setting Obscuration Reading and and |
| • Remote Output (Alarm): | Reflector Reflector Voltage - 15 to 32 VDC (Output voltage same as device (ft) (m) |
| input voltage) | Level 1 25% 25 16.4 to 120 5.0 to 36.6 Current - 15 mA maximum, 6 mA minimum (Output current Level 2 30% 30 25 to 150 7.6 to 45.7 |
| is limited by 2.2K ohm resistor) | Level 3 40% 40 60 to 220 18.3 to 67 maximum @ 32 V (heater only); Power Consumption - Acclimate ® nominal 1.6 W @ 24 V, maximum 3.0 W @ 32 V. Level 1 30% to 50% A1 80 to 150 24.4 to 45.7 Current - 450 mA maximum @ 32 V (per reflector); Power 40% to 50% A2 80 to 200 24.4 to 67 Level 2 Consumption (per reflector) - nominal 7.7 W @ 24 V, |
| maximum 15.0 W @ 32 V. | In addition to the four standard sensitivity selections, the detector has two Acclimate® settings. When either Acclimate® setting is chosen the detector will automatically adjust its sensitivity using advanced software algorithms to select the optimum sensitivity for the environment. The sensitivity will be continuously adjusted within the ranges specified in the chart above. Total obscuration can |
| BEAM355S. | From Panel Communication Line To Next |
| See electrical | or Previous 32 VDC Maximum Device |
| ratings. | device. Twisted pair is recommended Wiring Diagram 6985adjloc.tif Alignment and Adjustment Locations 6985wirerts151.tif |
| Pin 1 | Remote Alarm Out |
| Pin 2 | PARTS LIST Pin 4 |
| AUX (-) | Item Quantity Reset Input |
| Pin 3 | Test Input Transmitter/Receiver Unit 1 |
| Pin 5 | See RTS151/KEY Installation Instructions Paintable Trim Ring 1 for electrical ratings of the RTS151/KEY |
| RTS151/KEY | Reflector 1 |
| Wiring Diagram with RTS151/KEY | Plug-In Terminal Blocks 3 Isolator Shunts 2 Instruction Manual 1 Orange Sticky Paper 1 6985screwlocs.tif 6985part.wmf Housing Screw Locations DF-52408:B • 11/16/09 — Page 3 of 4 |
| AGENCY LISTINGS AND APPROVALS | PRODUCT LINE INFORMATION BEAMLRK: Long range accessory kit (required for applica- |
| BEAMMMK | BEAMHK |
| RTS151 | RTS151KEY (ceiling or wall mount kit sold sepa- rately) Acclimate® is a trademark of Honeywell International Inc. ©2009 by Honeywell International Inc. All rights reserved. Unauthorized use of this document is strictly prohibited. This document is not intended to be used for installation purposes. We try to keep our product information up-to-date and accurate. We cannot cover all specific applicat |
* 規格以原廠最新 Datasheet 為準。
下載完整PDF規格書 →DF-52408 honeywell BEAM355 and BEAM355S亦適合以下專業服務機構使用，保安同合規要求同一般商鋪唔一樣，歡迎查詢度身方案。
HKEZIT 提供原廠行貨連保養，DF-52408 原廠行貨連保養，提供上門評估、安裝、防區設定及使用教學一站式服務，全港 32 區均有服務。
詳細規格請參閱上方規格表；我們會按現場環境（商舖、辦公室、倉庫、住宅）設計防區及感應器布局，並提供整體方案報價。
可按需求配置本地警號、手機 App 推送或短訊通知；亦可與 CCTV 聯動，觸發時自動錄影存證。
兩者屬同系列產品，實際應該邊個型號更適合，需視乎現場環境同需求而定。歡迎直接聯絡我們免費現場評估，由工程師建議最合適方案。
HKEZIT 提供 DF-52408 原廠行貨連保養，安裝後如有故障可直接聯絡我們安排上門維修，毋須自行聯絡原廠。詳情請參閱防盜報警安裝工程頁面或聯絡我們查詢保養範圍。
HKEZIT 於全港各區提供 DF-52408 honeywell BEAM355 and BEAM355S供貨連專業安裝服務（裝ALARM、裝防盜、裝警鐘），熱門地區包括：沙田防盜報警系統安裝、油麻地防盜報警系統安裝、深水埗防盜報警系統安裝、灣仔防盜報警系統安裝、筲箕灣防盜報警系統安裝、紅磡防盜報警系統安裝、荃灣防盜報警系統安裝、葵涌防盜報警系統安裝。港島、九龍、新界全港 32 區均有上門安裝，歡迎聯絡我們查詢 DF-52408 香港價格連安裝報價。
DF-52408 honeywell BEAM355 and BEAM355S適合多種場景使用，以下為部分常見安裝場景，歡迎查詢是否適合您的現場環境。
律師事務所裝防盜系統，文件檔案室紅外探測、門磁窗磁全面佈防，非辦公時段自動戒備配警鐘聯動保安公司，24小時中央監控站接報即時通知，誤觸發率低唔驚動客戶機密資料。持牌團隊免費勘察、明碼報價，中環、金鐘等法律樓層即約評估。
WhatsApp 查詢 →珠寶鑑定拍賣行裝防盜系統，展廳夾萬震動探測、紅外幕簾防破窗、緊急按鈕直通保安公司，24小時中央監控站聯防配合CCTV追蹤，誤觸發率低確保拍賣現場運作暢順。免費上門評估、高保安方案報價，中環、金鐘拍賣行即約勘察。
WhatsApp 查詢 →私人銀行財富管理裝防盜系統，貴賓室金庫紅外入侵偵測、緊急求助按鈕防劫、震動感應聯動保安公司，24小時中央監控站接報，高保密佈點不影響客戶洽談體驗。持牌團隊免費勘察、明碼報價，中環、金鐘金融區即約評估。
WhatsApp 查詢 →信託公司、家族辦公室裝防盜系統，檔案室及會議室門磁窗磁佈防、紅外探測非辦公時段自動戒備，警鐘聯動保安公司同24小時中央監控站，誤觸發率低保障客戶私隱同資產紀錄安全。免費上門評估、高保安方案報價，中環、金鐘專業樓層即約勘察。
WhatsApp 查詢 →商鋪裝防盜系統，捲閘震動感應、門磁窗磁、紅外幕簾防爆竊，收銀緊急按鈕連警鐘聯動保安公司，24小時中央監控站接報，誤觸發率低唔怕熄燈後保安巡邏誤觸。免費上門評估、明碼實價報價，旺角、觀塘等旺區商舖即約勘察。
WhatsApp 查詢 →村屋、獨立屋裝防盜系統，圍欄周界紅外對射、門窗磁感全面佈防，手機App遠程佈防撤防，警鐘聯動保安公司同24小時中央監控站，誤觸發率低適合寵物出入唔會亂響。專業團隊免費上門評估，元朗、屯門村屋一帶即約勘察。
WhatsApp 查詢 →查看更多防盜報警適用場景，請參閱 防盜報警安裝工程。
如需整套防盜報警方案，請參閱 防盜報警安裝工程。