| Technology | 4-electrode electrochemical |
|---|
| Measurement Range | 0 ppm CO to 20 ppm CO |
|---|
| Maximum Overload | 50 ppm CO |
|---|
| Onboard Filter | to remove SOx/NOx/H2S and O3 |
|---|
| Sensitivity* | 375 nA/ppm ±125 nA/ppm |
|---|
| Response Time (T90) | < 60 seconds |
|---|
| Resolution* | Ø18,5 (when using recommended 10 ppb electronics) |
|---|
| Baseline Offset* | <±200 nA |
|---|
| Repeatability* | < ±3 % of signal Ø31,5 |
|---|
| Linearity** | linear |
|---|
| Ø23,6 | 1,4 |
|---|
| Low Detection Limit* | 40 ppb (slot for o-ring) ELECTRICAL |
|---|
| Recommended Load | 15,0 68 Ω Resistor |
|---|
| Sensor Bias Voltage | O mV |
|---|
| MECHANICAL | 4,8 3,4 |
|---|
| 重量 | 9g |
|---|
| Outer Plastic Body | Ø24,0 ABS Material |
|---|
| Contact Material | copper with gold coating 90° Orientation Sensitivity none Sensing ENVIRONMENTAL |
|---|
| Operating | Counter |
|---|
| -30°C to 50°C (55°C intermittent***) | Reference Temperature Range Operating Humidity 15 %RH to 90 %RH non-condensing Ø22,0 Range |
|---|
| Recommeneded | Ø17,0 0°C to 20° in original sealed container Storage Temperature |
|---|
| Typical Applications | ambient environmental monitoring |
|---|
| Auxiliary | 4X Ø1,0 LIFETIME |
|---|
| Storage Life | 6 months in original sealed container 5,0 Long-Term Sensitivity < 10 % signal loss per annum Drift* Dimensions mm |
|---|
| Expected Operating | All tolerances ±0,15 mm unless otherwise stated two years in air Life |
|---|
| Warranty | two years AQ7CO Carbon Monoxide Gas Sensor Datasheet | sps.honeywell.com/ast | 2 |
|---|
| Gas | Gas Concentration Cross Interference |
|---|
| Sulfur Dioxide (SO2) | 5 ppm 0% |
|---|
| Nitrogen Dioxide (NO2) | 5 ppm -3 % < X % < 5 % |
|---|
| Ozone (O3) | 1 ppm -7 % < X % < 4 % |
|---|
| Isobutylene (C4H8) | 1 ppm None AQ7CO Carbon Monoxide Gas Sensor Datasheet | sps.honeywell.com/ast | 3 m WARNING Honeywell warrants goods of its manufacture as being free of defective materials and MISUSE OF |
|---|
| faulty workmanship during the applicable | DOCUMENTATION warranty period. Honeywell’s standard product • The information presented in this warranty applies unless agreed to otherwise by product sheet is for reference only. Honeywell in writing; please refer to your order Do not use this document as a acknowledgment or consult your local sales product installation guide. office for specific warranty details. If warranted • Complete installa |
|---|
| expressed or implied, including those of | serious injury. merchantability and fitness for a particular purpose. In no event shall Honeywell be liable for consequential, special, or indirect , SAFETY NOTE |
|---|
| damages. | This sensor is designed to be used in |
|---|
| While Honeywell may provide application | environmental applications. To ensure assistance personally, through our literature that the sensor and/or instrument in and the Honeywell web site, it is buyer’s sole which it is used, are operating properly, responsibility to determine the suitability of it is a requirement that the function of |
|---|
| the product in the application. | the device is confirmed by exposure to target gas (bump check) before each |
|---|
| Specifications may change without notice. | use of the sensor and/or instrument. |
|---|
| The information we supply is believed to | Failure to carry out such tests may be accurate and reliable as of this writing. jeopardize the safety of people and However, Honeywell assumes no responsibility property. for its use. |
|---|
| USA/Canada | +1 302 613 4491 |
|---|
| Latin America | +1 305 805 8188 |
|---|
| Europe | +44 1344 238258 |
|---|
| Japan | +81 (0) 3-6730-7152 |
|---|
| Singapore | +65 6355 2828 |
|---|
| Greater China | +86 4006396841 AQ7CO Datasheet ECN NPI | 00XXXX-1-EN | 1 | 03/22 |
|---|
| sps.honeywell.com/ast | © 2022 Honeywell International Inc. |
|---|