| reception quality | ETHYLENE OXIDE (ETO-C), EXT. 0 to 500 ppm 10 ppm |
|---|
| - STEL, TWA, and peak values | RANGE |
|---|
| KEYPAD | 2 buttons for operation and programming FORMALDEHYDE (HCHO) 0 to 10 ppm 0.05 ppm |
|---|
| SAMPLING | Diffusion HYDROGEN (H2) 0 to 1,000 ppm 10ppm |
|---|
| HYDROGEN CHLORIDE (HCL) | 0 to 15 ppm 0.2 ppm |
|---|
| CALIBRATION | Automatic with AutoRAE 2 Test and Calibration System2 or manual |
|---|
| HYDROGEN CYANIDE (HCN) | 0 to 50 ppm 0.5 ppm - Wireless remote alarm notification; audible (95 dB @ 30 cm), vibration, visible alarm (flashing bright red LEDs), and on-screen HYDROGEN SULFIDE (H2S) 0 to 100 ppm 0.1 ppm |
|---|
| ALARM MODES | indication of alarm conditions. HYDROGEN SULFIDE (H2S), EXT. RANGE 0 to 1,000 ppm 1 ppm - Man Down Alarm with pre-alarm and real-time remote wireless HYDROGEN FLUORIDE (HF) 0 to 10 ppm 0.1 ppm notification Continuous datalogging with a three-month capacity METHYL MERCAPTAN (CH3-SH) 0 to 10 ppm 0.1 ppm |
|---|
| DATALOGGING | (at one-minute intervals) NITRIC OXIDE (NO) 0 to 250 ppm 0.5 ppm - User-configurable datalogging interval (from 1 to 3,600 seconds) |
|---|
| NITROGEN DIOXIDE (NO2) | 0 to 20 ppm 0.1 ppm - Data download and instrument set-up on PC via charging and PC |
|---|
| COMMUNICATION AND | comm. cradle OXYGEN (O2) 0 to 30% Vol. 0.1% Vol. |
|---|
| DATA DOWNLOAD | - Data download via AutoRAE 2 Automatic Test and Calibration System PHOSPHINE (PH3) 0 to 20 ppm 0.1 ppm - Wireless data and status transmission1 via built-in RF modem (optional) ProRAE Guardian Real-Time Wireless Safety System or Closed SULFUR DIOXIDE (SO2) 0 to 20 ppm 0.1 ppm WIRELESS NETWORK Loop Network with the EchoView Host ToxiRAE Pro to Mesh Router, EchoView Host, or Mesh Reader2 |
|---|
| ~ 660 feet (200 meters) | 1 Wireless units have a functioning RF modem and are |
|---|
| WIRELESS RANGE (TYPICAL) | ready for wireless deployments; non-wireless units cannot ToxiRAE Pro to RAELink3 Mesh or RAELink3 Z1 Mesh modems |
|---|
| ~ 330 feet (100 meters) | be upgraded to wireless. Additional equipment and/or software licenses may be required to enable remote wireless |
|---|
| 工作溫度 | -4° to 131°F (-20° to 55°C) monitoring and alarm transmission. |
|---|
| HUMIDITY | 0% to 95% relative humidity (non-condensing) 2 Contact Honeywell RAE Systems for availability. IP-65 rating for dust and water ingress protection 3 Honeywell RAE Systems recommends calibrating sensors on DUST AND WATER RESISTANCE (validated by an independent test laboratory) installation. CSA: Class I, Division 1, Groups A, B, C and D. T-code T4 Class I, 4 Contact Honeywell RAE Systems for country |
|---|
| Zone 0 A/Exia IIC T4 | wireless approvals and certificates. Specifications are subject |
|---|
| SAFETY CERTIFICATIONS | ATEX: , II 1G, Ex ia IIC Ga T4 to change. IECEx: Ex ia IIC Ga T4 China Ex: Ex ia IIC T4 |
|---|
| EMC/RFI | EMC directive: 2004/108/EC |
|---|
| - Two years on O2 sensor | Ordering Information - Three years on H2S and CO sensors |
|---|
| WARRANTY | • Wireless or non-wireless versions are available - Two years on non-consumable components - One year on all other sensors, battery, and other consumable parts • Refer to the Portables Pricing Guide for part numbers |
|---|
| WIRELESS FREQUENCY | ISM license-free band. IEEE 802.15.4 Sub 1GHz for monitors, accessories, maintenance kits, gas, sensors, and replacement parts |
|---|
| WIRELESS APPROVALS | FCC Part 15, CE R&TTE, Others4 |
|---|
| RADIO MODULE | Supports RM900 Device Management with Honeywell SafetySuite |
|---|
| sps.honeywell.com/ | sps.honeywell.com/gb/en/software/safety/ connected-safety/safety-suite |
|---|
